Setup Guide

Router setup, Wi-Fi & troubleshooting

Everything you need to get your Zoiko router connected and online — the same guide our support team uses, in one scrollable page.

1

What's in the box

Before you start, check you have everything you need:

  • Your Zoiko router
  • Power adaptor
  • 1 × Ethernet (network) cable
  • 1 × broadband/phone cable (Standard Fibre / FTTC only)
  • Quick start card
2

Connecting your router

How you connect depends on the type of broadband you have. If you're not sure which one applies to you, that's completely normal — check the box your router came in, or use Start Setup Check on the main support page.

Full Fibre (FTTP)

Connect the Ethernet cable between the ONT — the small box already fitted to your wall — and the port marked WAN / Internet on your router.

Standard Fibre (FTTC)

Connect the broadband cable from your master wall socket to the port marked DSL / Line on your router.

Once connected, plug in the power adaptor and switch on at the wall.

Wait for the power and internet lights to turn solid white or green — this can take up to 5 minutes the first time.

3

Connecting to Wi-Fi

The Wi-Fi network name (SSID) and password are printed on the label on the base of your router.

  1. Open Wi-Fi settings on your phone, laptop or tablet
  2. Select the network name shown on your router's label
  3. Enter the password exactly as printed — it's case-sensitive

Once connected, try opening a website to confirm you're online.

4

Understanding your router lights

LightMeaning
Solid white/greenEverything is working normally
Flashing whiteStarting up — please wait
Solid redNo connection detected — check your cables
Flashing amberConnecting — this can take a few minutes
5

Quick troubleshooting

  • No lights at all — check the power adaptor is firmly connected at both ends and the wall socket is switched on.
  • Solid red light — check the Ethernet or broadband cable is pushed fully into the correct port at both ends.
  • Wi-Fi visible but no internet — restart your router: switch off at the wall, wait 30 seconds, then switch back on.
  • Still not working after a restart — use Setup Check or request a callback below.
6

Getting more help

If you've followed this guide and you're still having trouble, we're here to help.

Still stuck? Let's sort it together

Jump back to Setup & Installation for a guided check, live support chat, or to request a callback.